HVAC Parts & Accessories

HVAC Parts & Accessories

HVAC Parts And Accessories

Heating, ventilation and air conditioning (HVAC) is the general term for a product designed to keep an indoor climate controlled and comfortable. There are many types of HVAC systems, each with a lot of parts and accessories. 

Direct Brand have a huge range of quality, genuine replacement parts for whichever type you have.The most common are:

Set Descending Direction
View as Grid List

103 items

per page
  1. Trane White Rodgers Silicon Nitride 80V Hot Surface Igniter
  2. 220/240 Volt Biomass Igniter T?ndelement PTC DB1574
  3. 220/240 Volt Biomass Igniter Tandelement KIT DB9060
  4. 220/240 Volt Igniter T?ndelement keramiskt till Effecta Komplett III
  5. 220/240 Volt Igniter Woodpecker Biomass Pellet Boiler DB1525
  6. 41-411 Hot Surface Igniter
  7. Amana Hot Surface Igniter 768A-2 768A-842 11111701
  8. AO Smith 9002518015, 100108831 Igniter
  9. AO Smith 9003626005 Hot Surface Igniter DB6005
  10. AO Smith 9005958005,100110771 Hot Surface Igniter DB8005
  11. AO Smith State Water Heater Igniter
  12. AO Smith, State Water Heater Hot Surface Igniter - 9004504205
  13. AO Smith, State Water Heater Hot Surface Igniter 100109948
  14. Armstrong Flame Rod Sensor/Ignitor
  15. Armstrong Hot Surface Igniter 767A-372
  16. Bakers Pride M2140X And Nieco 10291 Igniter
  17. Baxter Ignitor 24V, 01-1000V9-00149
  18. Bradford White Hot Surface Igniter - 265-45543-00
  19. Bradford White Hot Surface Igniter 23949091800
  20. Carrier 318984753 Inducer Draft Motor Furnace Exhaust
Set Descending Direction
View as Grid List

103 items

per page

Standard Split Systems

These will be configured to suit the climate where the building is located. A furnace, normally gas powered, is paired with an air conditioner condensing unit which will be mounted outside. The warmer the climate, the higher the SEER (Seasonal Energy Efficiency Ratio) rating an air conditioning unit will need to have.

In very cold climates, both units may be used for heating, rather than air conditioning.

Ductless Split (or mini split) system

Mostly used where space is limited, or there is no existing ducting, the mini split system can also be installed into an extension to the property. It is not suitable for very cold climates and doesn’t offer the flexibility that a ducted HVAC product would offer. 

It is a great solution though. With one exterior unit forcing treated air to up to four internal units, the mini split system is economical and efficient.

Packaged Systems 

Suitable where a split system isn’t an option. All the major components are housed within one unit which is mounted outside the building. Far less efficient and prone to wear and tear due to being housed outside, but much quieter within the house. They may feature a furnace and an air conditioning unit, or be controlled by a heat pump. 

With so many configurations, fuel sources and style of HVAC products installed in buildings, a specialist engineer will probably be needed when repairs, installation or alterations are being planned.

There are many characteristics which need to be considered when choosing replacement parts:

Voltage - be sure to check that the component is being controlled at the expected voltage. Your engineer can confirm this.

Speed - some motor components may be for two speed units.

RPM (Revolutions per minute) - different motors run at a variety of speeds. Our support team at Direct Brand is always on hand to help you ensure your are ordering the correct part.

Amperage - with so many different HVAC options, thermal qualities and size of HVAC units, the amp rating should be carefully checked.

Horse Power - sometimes measured in kilowatts, matching the output of a units power is important when ordering your quality replacement parts.

Some of the most common problems with HVAC which may require replacements from our range of parts and accessories are:

Leaking Refrigerant - the fluids within an air conditioning unit’s coil cool and dehumidify the air for indoors. If air has stopped being cool, the fluid may well be leaking.

Thermostat Failure - before getting too involved in finding a fault in the entire working of the HVAC product, it is worth checking that all of the thermostats are providing accurate information.

Dirty / Clogged Filters - a general lack of maintenance can leave your system working inefficiently or causing components to fail.

Air Imbalance - In HVAC products with dampers in the ducting between rooms, these dampers compensate for different rooms’ climate. If the dampers are not correctly balanced, the system will be operating inefficiently.

Faulty Igniter-  A faulty igniter can lead to complete malfunction. Direct Brand stock the following igniters:

  • Furnace igniters

  • Boiler igniters

  • Hot surface igniters

  • Universal igniters

Whatever your HVAc requirements, see our range of HVAC accessories and parts above.